parameterization problems! ! !

[mario75]

Hello everyone

someone can give me advice,

I have to parameterize the length of extrusion of a pipe.. How can I do

I basically have a tube that goes inside thousands of axes because the only variable is the length, now I do not want to have a thousand parts with different lengths since it is always the same article, what I would like to get is to have a tube called master, which inserted in the various axes asks me at the time of insertion the length I want and that it should not have saved the component with the different size. .

I don't know if I've broken or we've understood!

Thank you! ! ! !

 

[davide75]

I would say that as the first message there is no bad...
You have to make an ipart.
Hi.

 

[PabloPicasso]

ipart, as suggested.

or you can use the frame generation features. automatically creates all pieces without having to model one by one with individual extrusions. you save a lot of time....

 

[davide75]

Yes, but in any case you always have to do the sketch of the size you want.with the ipart do the job once so that you turn the table by hand.