parameterize lines and arrays

[Andrew_]

Bye to all,

I created a nested parametric family and defined different types, reading on the internet I saw that there was the possibility to parameterize also commands like arrays etc. Then I thought I'd evaluate if it was possible to improve the family.
what I would like to do is to be able to parameterize array lines and commands to create additional plates like in the dwg file, with detachable and minor elements.

to now the various types created follow all the same scheme 4 wallpapers, rectangular plate etc... If, however, I could parameterize the lines that make up the rectangle from a full rectangle to a beveled rectangle (like dwg) and for the second possible type I can parameterize an array that can make me create from 1 to 3 types of detachable elements at will and not bound between them.
I searched online but I can't make a family like that. Does anyone have any ideas?

 

[Tristan]

Does anyone have any ideas?

large lines yes, but the topic is too vast and complex to be explained on a topic of a forum.
rather I wonder why you do not use the controls of the "steel" card that could solve a lot of problems, without losing your sleep on the loadable families

 

[Andrew_]

because we have different plates, which cannot be modified with those present in the steel, in fact, the family that I made with the square plate and the 4 wallpapers, all parameterized would suffice if they did not decrease the wallpapers and the plate did not change