SINCOSALD
Guest
Good morning to all...... I looked in the forum without results.
My question is the following. I would like to know if there is a possibility to bring the value of a parameter back to the properties of a part. I will explain better: I would like to create gears through a parametric model and bring in the properties, automatically, the value of the module and the number of teeth, primitive diameter.
Thank you.
My question is the following. I would like to know if there is a possibility to bring the value of a parameter back to the properties of a part. I will explain better: I would like to create gears through a parametric model and bring in the properties, automatically, the value of the module and the number of teeth, primitive diameter.
Thank you.