partial rounding on tangent chains - wf4

[Alberto.E]

hello to everyone, a question about raying.
Usually when selecting a coil to be radiated, pro engineer automatically makes the radius continue throughout the loop. It is possible instead to perform ray only in the selected edge and not on all as the software suggests?

Thank you.

tree

 

[maxopus]

I'll give you an example.
but do you need it with stop or gradually?

 

[Alberto.E]

both cases if possible. Thank you.

 

[maxopus]

Here are three examples:

4 rounding feature: create a curve and round through curve

feature flushing 5: activate the function>click on the edge> hold pressed shift>selections the two adjacent edges (curves)> go on pieces>pezzo 1 and you will see the handles> the draws back until the end of the straight edge.


feature redundancy 6: create a plan>activi the function>click on the edge> hold pressed shift>selections the two adjacent edges (curves)>transitions>selections transition 1> stop references>selections plan>selections transition 2> stop references>selections plan

not if there are other systems... at the moment I remember these

 

[Alberto.E]

thanks, always fast and very kind

 

[maxopus]

not always ... I am improving with age (only for kindness)