parts off axis compared to the floor

[deep70]

Hello everyone,
I'm not an expert in inventor 2017, today this happens to me:
I have to make a table of a toothed wheel, but the axis of the part is not parallel to the plane.
The wheel has been over by the customer and I'm not really like aligning it.
place a photo to make the idea better, and thank all in advance for the answers given.

 

[TECNOMODEL]

some solutions:
- Run the part with the command moves bodies and aligns it as you wish.
- when you click on custom view, you will see the part that you go to orientate as you wish, give the ok and you will have the aligned view.

 

[deep70]

thanks to the technomodel response.
I'm very kind, as soon as I get back to the office, I try.
thanks again and good day.

 

[deep70]

some solutions:
- Run the part with the command moves bodies and aligns it as you wish.
- when you click on custom view, you will see the part that you go to orientate as you wish, give the ok and you will have the aligned view.

hi technomodel.. I'm trying. I don't see any "personalized" voices. .

 

[Tarkus]

a view so that the hive comes.. .
even to facilitate future changes, I would rotate it with the command moves bodies or better, you will restart it from time to time:
put it in a set, ties to a plan of origin, derives the file in a .ipt, and interrupt the link.
and then delete the starting file.. .

 

[deep70]

a view so that the hive comes.. .
even to facilitate future changes, I would rotate it with the command moves bodies or better, you will restart it from time to time:
put it in a set, ties to a plan of origin, derives the file in a .ipt, and interrupt the link.
and then delete the starting file.. .

hi tarkus, I would say you're right, but sincerely I'd like to avoid handing to the model, from experience even to well. .
I managed to have a good result through the wheel command in the table... or better in the eyesight is not from 10... say.

 

[stefanobruno]

hi tarkus, I would say you're right, but sincerely I'd like to avoid handing to the model, from experience even to well. .

do as tarkus suggested, but keep the connection to the original.
so you get a correct table and keep the original to future memory.

 

[Tarkus]

do as tarkus suggested, but keep the connection to the original.
so you get a correct table and keep the original to future memory.

I said to erase the axieme from which to derive, the original file should keep it. . .

 

[TECNOMODEL]

hi technomodel.. I'm trying. I don't see any "personalized" voices. .

put the view on the table, click dx on the view cube, orientation view customized