paste an object on the new worktop

[kubbah]

is it possible to copy an object that stands on a work plan (which is perhaps horrizontal) and copy it on a new work plan that maybe is tilted to 45 degrees, in the way that even the rough object?

That is, keeping the reference to the plan, copying it having active the horizontal plane and then maybe changing the working plan and pasting it on this new plane, but in the way that this object is prone to itself, because maybe it had as a reference inclination to the work plane. +

Thank you 1000 for your help!

 

[kubbah]

I'll explain.


I am in the conceptual mass mode
I drew 2 reference lines
on both I put 3 points of reference (at the beginning, in the middle, at the end)
I click on a half point of reference, imposed the work plan as a perpendicular plan to the passing line for this point, and design a triangle on this work paino (to then have a mass passing by this profile)

Now I would like to copy this triangle and paste it on another work plan.. Is it possible?
Thank you.

 

[gfrank]

I think I'm not...
However, you can duplicate the reference plan and the triangle contained, and then, through the views n/e/s/o/3d, orientate the plan (command:ruota) to the desired position

p.s. don't you first draw a reference plan and draw the same triangle?