paste part of a block on the original coordinates

[Aurora_86]

Hi.
I have to copy elements contained in a block of a file and, copy them in original coordinates in a second file. I entered the block, selected the items that interest me, copied them. then I glued them into original coordinates in the target file, but the coordinates do not match. What's going on?

 

[MassiVonWeizen]

is it not easier to copy the block and explode it?

the internal coordinates of the block and those of the drawing are not necessarily corresponding.
you can have a circle in the block with the center positioned to x0,y0 while in the design the origin of the block is positioned to x1000,y2000

 

[Aurora_86]

the block is complex, it is full of elements. But I could actually put it on a layer, copy it into original coordinates, explode it, change layers to what I need, isolate the layer block and delete everything.
Thank you.

 

[MassiVonWeizen]

if the block is complex you explore it in the original file cups/covers what interests you in the new file and in the original file do n° cancel to return to the previous situation

 

[Aurora_86]

You are right, I always think of the longer procedures
Thanks again