fagil90
Guest
Good morning.
I have read various posts of people to crash inventor for problem during creations of threads.
I have a very strange problem that started after the office update (version 2013).
the table thread.xls is there, opens it, but in the modeling phase I do not open the part relative to the threads.
to understand, click "hole" and below you can choose between 4 types of holes (simple, with game, threaded and conical thread).
Here, the threads, I can't even put the "blue ball" to open and select the threads.
Can anyone help me? from the menus I can't tell if you can't fish the table.
and it seems strange because in the same folder there are also tolerances and those I have no problem.
Thank you all for your help!
I have read various posts of people to crash inventor for problem during creations of threads.
I have a very strange problem that started after the office update (version 2013).
the table thread.xls is there, opens it, but in the modeling phase I do not open the part relative to the threads.
to understand, click "hole" and below you can choose between 4 types of holes (simple, with game, threaded and conical thread).
Here, the threads, I can't even put the "blue ball" to open and select the threads.
Can anyone help me? from the menus I can't tell if you can't fish the table.
and it seems strange because in the same folder there are also tolerances and those I have no problem.
Thank you all for your help!