piece of twist

[LucaOt]

hello to everyone, I'm struggling with a particular easy invoice but I don't know how to model in solidworks because I've never happened. Can someone direct me?

 

[MassiVonWeizen]

use loft function with guide curves.

 

[MassiVonWeizen]

3 curves drive them with 2d sketch while the fourth you will have to do it with 3d sketch.

 

[LucaOt]

doing as you say, wouldn't you have the same thickness along the whole piece?

 

[MassiVonWeizen]

doing as you say, wouldn't you have the same thickness along the whole piece?

Of course.
if it did not have the same thickness would imply a processing and not a simple twist.
where do you read that does not have the same thickness?

 

[LucaOt]

You're right, my mistake. Thank you very much, you have been very helpful as usual

 

[MassiVonWeizen]

then post the result we compare it

 

[LucaOt]

I don't know why but I have the impression that if I took a thread and twisted it and folded it, I wouldn't get this visually. maybe doing everything in one loft?

 

[MassiVonWeizen]

I hoped utopianly that I would post the annex, otherwise what does it compare?

 

[LucaOt]

file

 

[MassiVonWeizen]

I don't have the complete design, but it doesn't look like a single piece to me.
Also the 3d sketch curve did not make it with a spline, but with a simple curve

 

[LucaOt]

The complete design is what I posted. I only have this. However, I imagined that in the workshop they took a thread and simply twisted it and folded it like that. I tried the "flee" function and does something that is similar to what I had in mind but you can't do it like that. I'll try