pipe development

[themole]

Good morning, I have to realize how attached you would do the curve part considering that it is not possible to turn the pipe in question ? I had thought to use the tube for straight parts and realize the curved part in tinted sheet.
suggestions? ?
greetings to all and good year.

 

[PIETRO2002]

is it not possible to bend the curve, perhaps by interposing a flexible core of support inside?

 

[themole]

is it not possible to bend the curve, perhaps by interposing a flexible core of support inside?

I contacted 3 companies quite valid in bending pipes but none managed to give me positive opinion on a pipe 80x40x2 without leaving "grinze".
I think it must be made of sheet metal the curve but I was looking for a feedback on feasibility.

 

[PIETRO2002]

I contacted 3 companies quite valid in bending pipes but none managed to give me positive opinion on a pipe 80x40x2 without leaving "grinze".
I think it must be made of sheet metal the curve but I was looking for a feedback on feasibility.

Surely you can do it with the two sides laser cut and the two sheet metals and then weld all to tig, but I think it has a non-sustainable cost!