"pipe to pipe"

[Inventore]

a greeting to all.. .
they asked me if it is possible to develop pipes of a pipe pipe pipe pipe pipe (conducts formed by coils of pipes for cooling gas at high temperatures) with inventor.

I made some attempts but I didn't get any results. Is there anyone working in this particular field?

Thanks :finger:

 

[Serious]

but I'm learning from scratch to use the "piping" module.

The problem is, it's a very short form, apparently.
in the sense that looking on the internet, there is nothing: No guides, no explanatory videos, no tutorials, etc.
if not 2-3 cocks. .

And the general guide inside "inventor" sucks.
: