pipes for clamps

[braunfish]

I can't find them in the content center.
those I need are the typical welded iron tubes for locks, type sf1, sf2, sf3.

thanks for any help

 

[bradipo666]

I'll take the discussion. . .
I would need 3d models of clamping tubes (1a, 1b...)
I tried to draw them with inventor but I can't make the fold-shrink (with game=0)

 

[Tarkus]

the fold crushes with game=0 I don't think you do any solid modeler, from a game of 0.001, I don't think it changes very much to the practical act on the design of a fixture... .

 

[bradipo666]

to the practical act not, but to bind it creates problems... I "resolved" doing a solid that I then emptied. is it possible to use it as an element in the chassis generator? Thank you.

 

[Zac69]

to the practical act not, but to bind it creates problems... I "resolved" doing a solid that I then emptied. is it possible to use it as an element in the chassis generator? Thank you.

Yes, if you use the variables he wants to recognize it in the chassis generator