pmago
Guest
hello to all, I would like to know if it is possible to lay the pipes on three-dimensional reference curves.
Until now I have always laid the pipes using sketch 2d in sequence. Now instead I would like to use a reference curve (parameter from equation) as a path but I can't get the "solidification" of the curve through the route-> follow command. .
thanks for any advice.
Until now I have always laid the pipes using sketch 2d in sequence. Now instead I would like to use a reference curve (parameter from equation) as a path but I can't get the "solidification" of the curve through the route-> follow command. .
thanks for any advice.