vale79
Guest
Hello everyone
I have to draw very simple hydraulic patterns, like solar kettle, boiler, mixer, sanitary system.
I wanted to understand if I can use the inventor piping module or if I should draw the pipes and fittings and bind them together in part/axieme environment.
I tried to look at the posts on the topic but the most recent are of 2012 if not mistaken.
I managed to draw paths but I did not understand how to handle them, what are the primary and secondary, and especially how to do if I always find myself with a tube with male thread that ends up against a piece also with male thread.
Most likely to do these patterns with normal parts I would have employed much less than writing this post, but my purpose is also to learn something more than inventor.
thanks in advance for any help
hello and good holidays to all
That's right.
I have to draw very simple hydraulic patterns, like solar kettle, boiler, mixer, sanitary system.
I wanted to understand if I can use the inventor piping module or if I should draw the pipes and fittings and bind them together in part/axieme environment.
I tried to look at the posts on the topic but the most recent are of 2012 if not mistaken.
I managed to draw paths but I did not understand how to handle them, what are the primary and secondary, and especially how to do if I always find myself with a tube with male thread that ends up against a piece also with male thread.
Most likely to do these patterns with normal parts I would have employed much less than writing this post, but my purpose is also to learn something more than inventor.
thanks in advance for any help
hello and good holidays to all
That's right.