plastic injection moulds - holes on external surfaces

[Daniele-san]

if I recall the zytel is a glass load, with a fairly high percentage.
Could make you some trouble.
with the abs, instead, you could do it quietly.

hi technomodel,
from its datasheet https: / / dupont.materialdatacenter.com / products / datasheet / us / zytel% c2% ae% 20st801% 20nc010a

 

[TECNOMODEL]

hi technomodel,
from its datasheet https: / / dupont.materialdatacenter.com / products / datasheet / us / zytel% c2% ae% 20st801% 20nc010a

does not work the link, however it is possible that I have wrong, I went to memory

 

[Daniele-san]

does not work the link, however it is possible that I have wrong, I went to memory

I try to send it directly

 

[TECNOMODEL]

I try to send it directly

I had forgotten that in the family there were also unreinforced people like this, I think you could try that way.

 

[Daniele-san]

I had forgotten that in the family there were also unreinforced people like this, I think you could try that way.

Thanks for consulting