sbiru88rn
Guest
Good evening to all,
I have been following your discussions with interest for several years, but until now I have never participated. are a plastic design neophyte and I would like to ask you a couple of questions about tolerances in injection molded artifacts in pc:
- are there regulations defining the conditions (environmental, piece or instrument) to which the manufacture must be measured to verify its tolerances (between producer and contractor)?
- with regard to the minimum tolerances which may be required, it is necessary to refer to the regulations (e.g. 16901 or nf t 58000) or to descend even below the standard values?
Meanwhile, trusting in your experience, I thank you for your availability.
I have been following your discussions with interest for several years, but until now I have never participated. are a plastic design neophyte and I would like to ask you a couple of questions about tolerances in injection molded artifacts in pc:
- are there regulations defining the conditions (environmental, piece or instrument) to which the manufacture must be measured to verify its tolerances (between producer and contractor)?
- with regard to the minimum tolerances which may be required, it is necessary to refer to the regulations (e.g. 16901 or nf t 58000) or to descend even below the standard values?
Meanwhile, trusting in your experience, I thank you for your availability.