post processor

[shinjy01]

Hi.
Do you know that company that creates post porcessor?? ?
I could use edgecam for hurco control!

Thank you.

 

[corsaro33]

Hi.
I don't know edgecam,
But I know there's a nice program inside.
(code wizard) you need to customize or create postprocessor.
greetings

 

[shinjy01]

Thank you, but unfortunately, to create from scratch or even modify another already existing post, I don't even know where to start, and I wouldn't trust sure to pass it in the car

 

[flfn]

Hi.
If I can give you some advice, I'll go interfering with a new cnc.
amount a program already done and operated by the cnc, and then change the post proccesor ad hoc, and I try it in simulation.
However, you need to have iso code bases and machine programming.

greetings

 

[shinjy01]

the fact is that I have no idea how it is done and how a post processor works, and unfortunately programming iso I don't know almost anything, since I do everything in conversation!!
cnc is a hurco .
I think I need someone who knows how to do these things, or just what he does at work!! :

 

[PopeYe]

Hi, try asking directly to edgecam or take a look here.... http://www.duezero.it/

 

[shinjy01]

Unfortunately, I have already tried to ask, but if you don't buy the software directly from them, they don't do anything to you, or if you don't buy the software directly from them.

the site I saw it, but it was you a stand at the hemo of last week and the official site is last updated only 2 years ago

 

[regola]

Bye.

I can try and help you.

I would need the characteristics from the machine (if it is a center or a lathe)

How many axes, etc.

It would also serve a program that already shot in the car.

Say hi.

 

[shinjy01]

Hi, I'd be very grateful to you.
Maccchina is a 3-axis center of the hurco.
for the programs, for the moment has never turned any program (created by a post) since I had taken it new, but there are only programs in iso that already put them in, both to verify the operation, and for some exercise.
I can try to download those and try to passarteli!
Give me your mail, so I try to send them.
Thank you very much:

 

[c3kkos]

for a three axes should not be very difficult. .

I tried to do that for a 5 axes with powermill.. . .

I let it go. impossible for one person

 

[stokes]

hi, I will certainly be late, but I would recommend a very good company that produces ad hoc postprocessor for azeinde: i.a.s., is located in Florence.

Hi.

 

[claudiu220405]

hy all
smebody an help pe with a postprocessor for selca s4040/
grazzie!
sorry for not speaking italian!

 

[aplai]

Hi I see you're a postprocessor expert, would you tell me where I find a guide to interpret the variables coming from the cam rhinonc?
Thank you.

 

[gmarco]

Hi I see you're a postprocessor expert, would you tell me where I find a guide to interpret the variables coming from the cam rhinonc?
Thank you.

Hi aplai,
for "rhinonc" do you refer to the integrated cam in rhinoceros?

 

[aplai]

That's right.
I would like to know the sygniphaecto of all the variables of the file.lav
and cycles exactly what they need
Can you help me?
Thank you.

 

[beduino65]

procam of padova if you have not already done hello