Prima vista and tavola

[TheOne.PC]

Hello everyone
the cartella takes the information from the first sight they place on the table.

for carpentry assemblies I make a sheet 1 with welding positions and a sheet 2 containing all cuts,
arrived in the middle of sheet 2 I realize that I have not placed as before sight that of the axieme (from which
must take the references the table)

Is there a way to tell the cartiglio from which view to take references?

I hope I have explained in an understandable way
Thank you.

Hello! !

 

[Zac69]

I don't know. I tried to rename the views so that the view1 is what I want, but inventor does not change the data on the cart. I think it depends on how he numerates the views internally. I'll make some evidence, and if I find a solution, the place.
for now the only one is: you have the views trying to put first what you need (maybe you put a writing on the template you remember and delete it after you put the view). do not put the quotas and in the end controls the cartilage. if you do not delete the views from the first until the desired data appears. Maybe snoring, maybe more difficult to write than to do, but it's the only one that comes to mind.

 

[eugenesis]

Have you tried to exchange views by dragging them from the browser??

 

[TheOne.PC]

Have you tried to exchange views by dragging them from the browser??

non si spostano

 

[eugenesis]

Then try to take the first view, do copy-paste in another sheet, delete the original and then again
copy-paste reverse from the new sheet to the old; your first sight will now be in the tail to the others!!
It's a little "arzygogular" but it should work.

 

[TheOne.PC]

Then try to take the first view, do copy-paste in another sheet, delete the original and then again
copy-paste reverse from the new sheet to the old; your first sight will now be in the tail to the others!!
It's a little "arzygogular" but it should work.

in the original sheet there is not only a view, but "n"

 

[stefanobruno]

after you have the correct view on the correct sheet, with the correct writings, go to the sheet where all the others have remained, all selections and draws in the correct sheet.

Is that correct?