Spit19
Guest
Good morning, everyone.
work with pros for about 4 years and need to interface it
to a cnc pantograph.
internally to pro/e I see that there is the item manufacture from the new menu etc.,
then to set in various stages all the commands.
now I wonder but you can use pro/e to make my 3d models without further cam (obviously
creating a post processor) or should I buy a dedicated cam or additional module?
Thank you very much
work with pros for about 4 years and need to interface it
to a cnc pantograph.
internally to pro/e I see that there is the item manufacture from the new menu etc.,
then to set in various stages all the commands.
now I wonder but you can use pro/e to make my 3d models without further cam (obviously
creating a post processor) or should I buy a dedicated cam or additional module?
Thank you very much