problem artlantis

[iorim]

Hello, I should make a building entirely covered in aluminum panels. I did three d in autocad. the panels I shaped them one by one to read the plot of the whole prospectus. when I go import the model into artlantis the panels are displayed as if it was a single block in the sense that you no longer read the board plot. How can I solve this? . . .

 

[render54]

here we are:4410: all very good
but not:36_6_6:
if you put a couple of pictures
type: before and after
Maybe we realize your problem
Hi.
♪

 

[iorim]

You are perfectly right... I attach two pictures: one is the three d of autocad the other is the rendering of artlantis

 

[render54]

if when sending messages go to advanced mode, you can insert them directly

to look at the images I can assume that the panels created by you are parallelepipeds with net edges, in phase of rendering are seen as a unique wall,
If so you can follow 2 roads:
1- 3d modeling: smooth the edges of the panels or round or linear, or create a step back along the edges
2- create a material with a bump map of the size of the paneling and place it correctly.

I attach you a couple of pictures where the bump map creates on the countertop the square of the panels, and on the pillar the horizontal rows

 

[render54]

time behind this problem had already been facedhttp://www.cad3d.it/forum1/showthread.php?t=25315

 

[render54]

I have to add: with revit
However, the programs of making everyone think in the same way