acant11
Guest
Hello everyone,
I created a cube, I selected the four sides that make up the cube face and with the command "create shape from selection" I created a spline.
Now if I go to the spline edit and use the "outline" command does not create an offset on the same floor of the spline but with a tilted angle. . .
I can't understand why... .
I created a cube, I selected the four sides that make up the cube face and with the command "create shape from selection" I created a spline.
Now if I go to the spline edit and use the "outline" command does not create an offset on the same floor of the spline but with a tilted angle. . .
I can't understand why... .