problem creations plans

[ZeroEvil]

Good evening,
I'm at first with inventor and I have a problem with creating work plans, I'll explain better. .

I have to create a hopper that goes from rectangle to rectangle only that one face is inclined by 35° compared to the other, if it was parallel I did the offset of the plane and it was all done, but how do I create my second floor to a certain offset but also tilted compared to the first?

Thank you.

 

[GianniM]

create a tilted plane compared to the reference plane and tangende to a edge. in our example I will call this plan "a".
create a second floor, we diactate "b", parallel to, at the desired distance.

 

[Tarkus]

make a sketch with a line perpendicular to the sketch plane you want to get, get out of the sketch and use the command "piano"
click on the line and then on the end of this line from the side where you want to create the plan.
with the sketch is easier and change the inclination and position of the plane.

 

[ZeroEvil]

now I try and then I let you know, in the meantime thank you

 

[ZeroEvil]

I managed, but I had to create the first sketch, then create a perpendicular line to the first sketch of the length I needed, to create a tilted line of the degrees I needed, then somehow I created a plan on this tilted line (I managed to place some points of reference) and from there I made my second sketch on the tilted plane, a little laborious. . .