problem di shading

[francescodue]

Hello, everyone.
I have a problem display.
As long as I'm in wireframe, it's all right, but when I go to shading, I get something weird.
I recovered this file from an old version of wildfire, and even there it gave this problem.
in practice is a rotated ellipse and then cut in half and subsequently emptied.
All right.
when I add the "gambo", the outer surface goes to a ball. I hope the image is clear enough.
and the problem also extends to all subsequent features.
Has anyone found this problem?
or do you have suggestions?
Thank you.

 

[tartufon80]

Bye!

I would try to increase precision. Maybe it doesn't solve but it's an attempt that costs little.

 

[francescodue]

Bye!

I would try to increase precision. Maybe it doesn't solve but it's an attempt that costs little.

Thanks for the answer.
but what do you mean to increase precision?
in the configuration editor I have "accuracy_lower_bound" set to .000001.
If that's not it, what should I change?
I think it's the only file that has this problem.

 

[tartufon80]

try to control the accuracy value you have set to

file->preparation->property model

I have the relative precision set on 0.0012 (which I think is the minimum taxable value).

 

[francescodue]

I have the same value (precision relative 0.0012).

 

[tartufon80]

I don't know, could you post a file so I try to open it and see what happens?

 

[francescodue]

I'll get you the file.
Meanwhile, thank you for your interest.

 

[tartufon80]

I opened the file and I have your same problem.
the strange thing and that if I stop at the preview of the feature is all correct, giving confirmation the visualization "strange".
I also tried to move some features on the tree (the shell especially after the extrusion of the stem), but without positive results.

I try to play some more, as soon as I have time. In the meantime, we hope someone more experienced than us can get you out of the mess.

 

[tartufon80]

I may have solved, but I don't know if this is acceptable to you.

I recreated a feature, that is the protrusion id5519, and its cut id5550.

if I don't remember badly it happened to us with old files coming from wildfire, especially with variable step wind sweeps. from there came to mind to replace a feature.

It seems to be right, but this only you can know.

 

[nino67]

Maybe I solved it with the original model, just insert a connection between the elliptical section and the stem.

greetings

 

[francescodue]

I was convinced that the answer was sent. Mah.
for tartufon80: it would be the best solution, unfortunately there are too many features that are connected and that lose references.
for nino67: your solution only creates some difficulties with other rays, but it is very fast.
Thank you both.