problem display solidworks

[Diablo94]

hello to everyone, on an old pc (windows xp) I installed for solidworks test 2012, but in the visualization of sketches I find the lines very thick... maybe from the photo you see little but still live they look huge.. is there way to reduce the thickness? thanks to all

 

[MassiVonWeizen]

I don't think there are settings for the thickness of them in sketch mode.
anyway attach a file with a sketch and a screenshot where you see well the increased thickness

 

[MassiVonWeizen]

I will never understand why to attach an image you have to take the picture, with all the problems that you carry behind, instead of using the computer itself.
pulsate mold and paint to say the most land that there is

digital native mysteries

 

[meccanicamg]

It is normal because you are using the video card with 12x or 8x acceleration....or in the solid configuration you are using the display option (which you don't remember as it is called) that finishes the lines. In fact at work I removed the option years ago and the lines I see them thinner and almost serrated.
is the only option that regulates edges and sketch lines at the same time.

 

[Diablo94]

#Massi I didn't make the screen because the pc wasn't connected to the internet and taking a flash drive and turning it on the other was too slammed, I made a photo and so.. However if there are no possible options I leave it to lose. Thank you.

 

[Diablo94]

#meccanicamg do you remember where I can find that option "get lines"?

 

[meccanicamg]

I have my memory on the floor at this time....just I find it or I remember it... http://help.solidworks.com/2017/italian/solidworks/sldworks/hidd_options_edges.htm see anti alias active or not.

 

[MassiVonWeizen]

the anti alias does not have to do with the display of the thickness of the lines, but with the definition of the tract when they are inclined.
at least to me changing the status of the option does not change the thickness of the line.
could be a question of video card, some pattern setting, of an option of the system I do not remember, of other; I asked a file with a banal sketch just to verify that opening it shows or not the same situation and then exclude hypotheses.
but of course if it is a slam to pass from one pc to another for those who ask questions (conscious of the fact that the image could not be good enough to understand the problem) I look good to stress them over.

 

[meccanicamg]

I remove the option and then set the graphics card to increase the speed and not the quality I get very thin lines visually. otherwise they become beautiful fillets and big. this is on normal pcs and workstations.

 

[Per5]

Excuse me but how do you dictate the graphics card for speed? I from technical advice of solidworks I disabled the anti alias to speed up the system. but lately I have the software that in the table shows me the sketches with thicker lines than before and does not maintain the color setting quotas and axes that I set. the thickness is set on 0.25 , I don't understand based on what changed my design display

 

[MassiVonWeizen]

in the table, things are different from the environment, or together, because being an environment dedicated to the two-dimensional representation of the model, the settings of the entities are greater.

 

[lukaskupasz]

solidworks crashes while displaying results in autodesk nastran in-cad

 

[MassiVonWeizen]

solidworks crashes while displaying results in autodesk nastran in-cad

Good morning.
Then what do you want to know?
and what does it have to do with the discussion?

 

[meccanicamg]

a svitol drip and unlocks