cubo
Guest
hello to all, I find myself having to add "material" to multiple faces of a solid and this "added material" must follow the existing profiles (forms, radiations etc.).
Attached I put:
- an igs of a small example
- a pdf where I place the face on which to add the material and also the sforms that should have (even without the sforms of 2° I would make it go well the same).
Usually to make these changes I use the function "face post" but in several cases (cases) it does not work me.
Thank you.
Attached I put:
- an igs of a small example
- a pdf where I place the face on which to add the material and also the sforms that should have (even without the sforms of 2° I would make it go well the same).
Usually to make these changes I use the function "face post" but in several cases (cases) it does not work me.
Thank you.