problem view split and interrupt

[tmeinventor]

Hello everyone

use inventor 2010

I have this problem, in a design I need to make a split view but also the interrupted command

I try to explain in detail

In practice I have a beam where I have to "shoulder" a plate to show the asola...but the beam is very long and for the scale and format that they have imposed me to hold it forces me to make an interrupt

the problem that I detect is that if I design the sketch for the split view also resulting from the projection of a edge of the plate, as soon as I interrupt and the beam shortens you do not take behind the sketch for the split view... is there a way to overcome the problem?

one I found is to try to reposition to the eye the sketch by moving it to the area where, hypothetically the plate is placed on the beam not interrupted... but you don't seem to function perfectly

This situation unfortunately will turn back on other tables

I hope in your suggestion

Thank you

 

[stefanobruno]

before preparing the sketch for the split view, you must have selected the pane that contains the reference view of the sketch itself.
If you do this, 90 out of 100 you bring the rift everywhere, otherwise the sketch will never follow the resize.

Bye.

 

[tmeinventor]

I had done so... then strangely I restarted x other reasons and now it works properly

Thanks anyway