problem with a ramp

[Danig]

I have to make a ramp, small, which starts from a lower level and arrives 30cm higher.
the contours are curved but this is not the problem: I can't run it like I do.

I'll explain better. imposed as the lowest worktop, design the ramp, associate at the level 30cm higher and conclude the design.
the ramp goes out correctly if it wasn't for the fact that it is reversed!

How do I tell him that on the other hand he has to get up and that instead here he has to flatten himself? ?

already that there are, once solved, how to cut the floor that will overlap to the ramp? If I make size geometry it doesn't make me select the floor or the ramp. .

 

[frcprogetti]

when you are in drawing mode appears - as for the stairs - a small arrow, click it to reverse the sense of ascent.
Hi.

 

[Danig]

when you are in drawing mode appears - as for the stairs - a small arrow, click it to reverse the sense of ascent.
Hi.

There's nothing here. Just the green edge, the two black lifts and a blue central line, nothing else.
which then, if I draw it by hand, scoring the contours first and then the two raises, how do I put the arrow?
I repeat, I did so, but also by selecting directly "rampa" it does not show me any arrows. .

 

[frcprogetti]

Sorry for the inaccuracy, you have to click the ramp not in drawing mode. the arrow is small but there should be

 

[Danig]

Sorry for the inaccuracy, you have to click the ramp not in drawing mode. the arrow is small but there should be

that it was far from the ramp and sowing from the section line

well, now how do I cut the floor that by force of things protrudes?

 

[frcprogetti]

Right now... change the floor profile