problem with frigato

[BonzoRosso]

good evening to all, my problem is the following, as you see from the attached image I can realize a folded making a tear along the long side... while I would like to make the tear on the short side... the thickness is 3 mm and the fold thickness is 5 mm.
Can someone help me?

 

[DANI-3D]

Hi.
no problem, but there is make-up, in sheet metal conversion choose edge laceration and select the edge on the long side, then make a tear connection on the short side and then remove the first edge laceration.
probably to make the state slowly will also need a tear on the edge.

 

[BonzoRosso]

the problem is that when I tear edge, selecting the long side fails regeneration. . Surely I'm wrong by attaching you an image to make you understand dani
we say that I have "resolved" by making the folds first, and then removing the corner surface, and then going to create a tear

 

[DANI-3D]

after making applications -> sheet -> shell, you have to make sheet conversion ... but I have the impression that you have gone wrong with the initial extrusion. Monday, when you come back, I'll give you an example. good 1 May

 

[DANI-3D]

Hey, there it is.

 

[BonzoRosso]

I'm sorry if I ask you, but is it possible that I do not have the protruding command? in the blend command does not make me do the commands you use... However the result is very similar to the one I got.. I think I still have to bang a lot of my head to figure out how the sheet package works... I also saw that you manage developments as variants is just because you did a .prt fast or brings advantages? ?

 

[DANI-3D]

... the protruding command...

is the sweep command -> protrusion

... I think I still have to bang a lot of my head to figure out how the sheet package works. . .

In fact it is a vast module, where it serves a little experience, but from nice satisfactions.

... I saw that you manage developments as variants...

is the best system to be able to recall in the drw both the 3d model and its flat state, moreover with this method you can easily manage the features that differentiate the part from its development, type pre-holes instead of threaded holes, microjunctions etc.

 

[blubossa]

Hey, there it is.

Hello, dani-3d,
I opened with creo2 the sheet you posted, and it is clear the approach........... .
But if I use the preview command of the explained creo does not allow me to make it the variant..... seems that you do not accept this kind of solution............

Have you tried?

bb

 

[DANI-3D]

Hey, bb, how's everything okay?
I reopened the sheet too, with wf5 there are no problems I do quietly even the flat state, concreus I can not verify.

 

[tartufon80]

I reopened the sheet too, with wf5 there are no problems I do quietly even the flat state, concreus I can not verify.

verified myself, everything ok with creo 2.