problem with iproperty 2.5.0

[Esselle]

Hello, use inv 2010 and xp. I have always successfully used iproperty on inv 2008, but after switching to 2010 every time I go to save parts or assemblies that contain ipt made of sheet metal I get this error: run-time error '5'
call routine or argument not valid.

can you tell me what can be and how to solve it?

Thank you in advance.

 

[Avoplus]

Have you verified that iproperty 2.5.0 is compatible with inv2010?

 

[Esselle]

Have you verified that iproperty 2.5.0 is compatible with inv2010?

Actually, the programmer's website is not about 2010. I use them to insert the mass and scale of the drawing into the cartilage, can in case I reset these variables with values that are already within inv 2010? Unfortunately I always miss the time to experiment.

Thank you.

 

[Peppe]

Actually, the programmer's website is not about 2010. I use them to insert the mass and scale of the drawing into the cartilage, can in case I reset these variables with values that are already within inv 2010? Unfortunately I always miss the time to experiment.

Thank you.

Save. qui

 

[Esselle]

Save. qui

Thank you very much!