Erikilrosso
Guest
hello to everyone, I've been missing for a while and I hope to find you in great shape. I have a couple of problems due perhaps, to the fact that I haven't taken revit in my hand for a couple of years:
- I do not remember why a surface wall (inclined or not) is not a solid geometry and can only be modified according to the mass that produces it, so you must act on the mass. is not possible then, to make it a normal "muro"?
- I would like to lay the mass that produces the surface that generates the wall, so that by updating it to the surface it leads behind the holes: I know it's possible but I don't remember how to do it. the manual, slower and slower to open, doesn't say anything special, or I didn't find the subject.
Thanks and good work for those who still have it.
p.s. I stayed at 2012 (Revittian archaeology)
- I do not remember why a surface wall (inclined or not) is not a solid geometry and can only be modified according to the mass that produces it, so you must act on the mass. is not possible then, to make it a normal "muro"?
- I would like to lay the mass that produces the surface that generates the wall, so that by updating it to the surface it leads behind the holes: I know it's possible but I don't remember how to do it. the manual, slower and slower to open, doesn't say anything special, or I didn't find the subject.
Thanks and good work for those who still have it.
p.s. I stayed at 2012 (Revittian archaeology)