problema crash proe

[cilly]

hello to all, it happens to me that after closing a fairly full set, consisting of traditional solids, commercials downloaded from the internet and parts made in sheetmetal mode, and just after doing the purge, I close the program, without any notice. I've already done a modelcheck with a lot of problems in the various parts. Can these be the ones who tilt the program? I am now solving them one by one, but they are problems of the type "features with reference of edge" or "spigoli short", or parts that contain various mirrors. how to solve this annoying problem? Many commercials have the problem, but given the quantity and variety of them I can't and I don't have time to put them in place.
Thank you.

 

[maxopus]

you can try to solidify the downloaded files and delete any undesirable residual surfaces.

 

[backoffice]

What is the problem then?
the purge commando? modelcheck? Anything else?

 

[ScMec]

Hi.
Once I crashed with axieme references in the parts, eliminating them all went well.

 

[cilly]

I tried to reassemble different details and to continue to launch the modelcheck, there are always some errors, but they are also present in other assemblies where closing them don't crash the program. to verify all references together in the parts, is there a precise and fast method? It's a problem that's making me waste my time. other controls or changes I can try to perform? I remember that the problem occurs when, closing all parts and assemblies, I execute the macro of purge.

 

[Prof.]

purge is not mandatory.