MassiVonWeizen
Guest
xxfast, you forgot to hide or eliminate the imported body. if you do flattening see that it is not closed as it should
xxfast
Guest
You mean that?
could you work to add edge closure?
could you work to add edge closure?
MassiVonWeizen
Guest
is why the post was opened.
I didn't find a direct solution and I had to get around with an escamotage doing a little clean work. is it a solid limit?
Dum
Guest
Hello Masses,
I'm sorry the late answer, but I just came by a client.
I tried to pat a little more using the direct modification.. .
wheel, transla, offset. .
but nothing, your solution is the one that comes closer to the customer's mod.
even if development is horrible and I dare anyone not to christonate me behind.
:
under the photo of a further test made (the one of sx), but as mentioned, the best result is with your procedure.
Thank you so much for the evidence!
I'm sorry the late answer, but I just came by a client.
I tried to pat a little more using the direct modification.. .
wheel, transla, offset. .
but nothing, your solution is the one that comes closer to the customer's mod.
even if development is horrible and I dare anyone not to christonate me behind.
:
under the photo of a further test made (the one of sx), but as mentioned, the best result is with your procedure.
Thank you so much for the evidence!
MassiVonWeizen
Guest
if it is not to be welded after you have to go over it to remove the surplus; a little work to give to specialized staff
if you have to weld it you don't need to close it so much
if you have to weld it you don't need to close it so much
MassiVonWeizen
Guest
I wonder, however, whether the development done with creo is then attainable in reality. This is because what a program says is not always cast gold. Do you have proof?
to achieve that effect you should first bend the "raggiatura" of the closed edge, and I do not think it is feasible, then the fold at 90° and finally the 45°
to achieve that effect you should first bend the "raggiatura" of the closed edge, and I do not think it is feasible, then the fold at 90° and finally the 45°
xxfast
Guest
I had a little time. I did one last test, but I still think it's only possible from a mold.
Dum
Guest
Hello, everyone.
Sorry, xxfast, I lost your message.
Now I try to download it and watch it.
Yesterday I was at the client, with the boss chino ready to take the dick: we call the final customer, we look at the problem together and...
opened a ticket with the assistance of sw.
:
They couldn't even come to terms with it.
I'm a little comforted.
If I get an answer from the sw, I'll keep you updated.
Thank you all!
Sorry, xxfast, I lost your message.
Now I try to download it and watch it.
Yesterday I was at the client, with the boss chino ready to take the dick: we call the final customer, we look at the problem together and...
opened a ticket with the assistance of sw.
:
They couldn't even come to terms with it.
I'm a little comforted.
If I get an answer from the sw, I'll keep you updated.
Thank you all!