ssayan79
Guest
hello to all
I'm new to the forum and I hope I didn't make mistakes in postwriting.
as written in the title I have problems in the table of a cross section of offset.
I created the section in 3d, but when I try to put it on the table, I can't do it properly.
in doing the section in the 3d I followed the following steps:
1) I entered the software menu for creating a new section
2) I selected offset -> two sides -> made
3) I created the curve sketch to do the section
no problem.
My only problem is the table.
I hope someone can help me.
In the meantime, I thank you all.
greetings
I'm new to the forum and I hope I didn't make mistakes in postwriting.
as written in the title I have problems in the table of a cross section of offset.
I created the section in 3d, but when I try to put it on the table, I can't do it properly.
in doing the section in the 3d I followed the following steps:
1) I entered the software menu for creating a new section
2) I selected offset -> two sides -> made
3) I created the curve sketch to do the section
no problem.
My only problem is the table.
I hope someone can help me.
In the meantime, I thank you all.
greetings