projection on surface with sketch of a sketch

[SATURNO07]

hello to all

I should project that fantasy (designed on sketch, even in a single way that is just a strip) on a surface with 5 degrees sform...that is, I should make the various superimposed bundles as seen in photo... I made the closed basket and I divided it in 4 then mirror it, but I can't wrap the sketch or maybe manage to stretch out the surface to then draw on it again...

 

[Lettore espatriato]

Good evening saturno07
In the meantime, you will find it here about the curve projections on the surfaces:
http://www.cad3d.it/forum1/threads/34591-profilo-su-una-superficie-in-rivoluzione-inclinata/page2

 

[Lettore espatriato]

Good evening saturno07
about the drawing to "onde":
(1) http://www.cad3d.it/forum1/threads/43841-curvare-una-superficieif you want to "transport" your profile from the top to the curved surface wrap.

2)creation curve from an equation of a sinusoid? you should find something on the online guide like:

formalreal.1 = 5*sin(5*pi*1rad*formalreal.2)+ 10

If you apply this law to an offset, you should find a form similar to your case.

 

[SATURNO07]

Good evening saturno07
about the drawing to "onde":
(1) http://www.cad3d.it/forum1/threads/43841-curvare-una-superficieif you want to "transport" your profile from the top to the curved surface wrap.

2)creation curve from an equation of a sinusoid? you should find something on the online guide like:

formalreal.1 = 5*sin(5*pi*1rad*formalreal.2)+ 10

If you apply this law to an offset, you should find a form similar to your case.

Okay, thank you, I'm trying tonight and I'm going to give you...

 

[Lettore espatriato]

Good evening saturno07,
Did you manage to do the synergy you needed?
Thank you.