propeller along a spline

[diego]

Hello, everyone!
I came across two cables that roll between them; The question is:how can I make two cables that run a spline? ?
.with the helical sweep is not possible because it requires the axis
..with the roll command is not possible because it does not develop the
surface on which the curve is rolled.
who can help me I'm sure that pro\e doesn't stop in front of such fesserie, but I do.
Thank you! look with anxiety!!! ! !

 

[pritio72]

Unfortunately, I don't know how to help you, but if someone is able to do it well, because the subject also serves as a person.
greetings

 

[cletus]

I attach an example (in wf2).
the topic has already been explained, look for the function Truffle

 

[pritio72]

I attach an example (in wf2).
the topic has already been explained, look for the function Truffle

thank you very much for the answer, although I had not done a research, sorry.:wink:

 

[diego]

:finger:
great works!!! ! !
Thank you very much cletus, you were very precious. Perhaps next time I will look better inside the forum....

thanks again:biggrin: