pros wf4 export single section

[francescodue]

Hello, everyone.
I need to completely redesign a part.
Unfortunately some sections are extremely complicated, so I thought I would copy them from the old side to the new one.
Is there any system?
thanks for the attention.

 

[Prof.]

If by sections you mean sketches, open these sketches and the sketch environment you save copy.
after which it amounts them in the new model always acting by the sketch with insert > file system.
Bye.

 

[francescodue]

Thank you.
It's something I didn't notice.
Everything works in export.
When I count the section, though, it tells me that the sketch has unclosed lines.
and obviously does not highlight the point.
already that we are on the subject, it also applies to normal sketches, there is an option to highlight the points that are to be settled (cut lines in more, close but not coincident points, etc.)?
Thanks again.