simolrg
Guest
I did not find the norm relative and I would need this information:
I made a drawing of an overall, and in the table I indicated the general tolerance that is 0.01 mmm, then of a detail of the overall I put a dimensional tolerance of + 0.20 mm because there is a welding. I wanted to know if the procedure is correct?
Thank you very much.
cordial greetings
Simone.
I made a drawing of an overall, and in the table I indicated the general tolerance that is 0.01 mmm, then of a detail of the overall I put a dimensional tolerance of + 0.20 mm because there is a welding. I wanted to know if the procedure is correct?
Thank you very much.
cordial greetings
Simone.