put in the table

[Maulex]

Bye to all,
I just put on the table a set with inventor 2014,
is it possible to unleash the design ....idw from the axieme to which it is connected?
In practice I want to make the table not dependent on any set.

Can you?

thanks to all

 

[Catafratto]

boh, I'd drive out and then I'd do that.
I don't even want to hear what you need for such a misfortune.

 

[gil]

you can export to cad as said by catafract, or hide unwanted lines and then create a sketch in which you draw what you want. However it seems to me something monstrous, like, what it says: I bought a bmw series 5, but I would like to put on wheels and panda engine.

 

[Maulex]

you can export to cad as said by catafract, or hide unwanted lines and then create a sketch in which you draw what you want. However it seems to me something monstrous, like, what it says: I bought a bmw series 5, but I would like to put on wheels and panda engine.

of course I haven't used inventor long.... .
the fact is that I have to put on the same design 2 views in 3d of a furniture, one with closed doors and one with open doors...
I accept tips

Thank you.

 

[Catafratto]

for this thing uses position representations: try to look on the online help if you have never used them, but basically you can "save" the axieme with various configurations of constraints, in your case that I know, before 0°, 45°, 90°. so you would have three "versions" of the same together and choosing one of the configurations the axieme assumes the various positions. the table can then be connected to these representations: you can put three distinct views by choosing for each location or even put a main one and other superimposed ghost online.

 

[Maulex]

Thank you
I try