put into the table flat tubes.

[stefano.tag]

Good morning to all it is a few days that I escape to be able to make a table of these 2 components.
I wondered what they cut them to the laser to do the program. I can't do anything clear. I'm just messed up.

I'd be grateful if some pious soul can help me! :

 

[controllofiamma]

Hi.
I would do that. Let me know if that's what you meant.

 

[stefano.tag]

Hello! I try to hear those of the laser cut if they can make the program from such an expanse,
Thank you very much for helping me even on the day workers should party!
As soon as I have some extra news I'll let you know!
Bye-bye!

 

[eboss]

Basically you needed sheet metal development...for cutting plane:finger:

 

[stefano.tag]

ok perfect thanks to everyone! They had asked me, however, to table a component, not a development. So I was sneaking up to create a table.
problem solved.