put on the scale

[reanimator]

Hello I apologize in advance if I did not correct the right section, I press that I am a lover, and I use cad at a base level, I have a project turned from pdf in dwg, now in pdf I have measurements of distances, in the dwg file unfortunately these measures are no longer scaled, someone would know to help me bring everything back in a 1:100 scale? allego files to better understand my problem

 

[MassiVonWeizen]

- selections all drawing
- scale command
* from here on, read what the command bar asks; in parentheses what you have to do)*
- specific base point (the beginning of a quota is ideal)
- scale factor (digita r reference)
- reference length (check the point used for the base point)
- second point (select the final point of the quota)
- specific new length (write the value from the quota)
*now you have real scale design*

 

[reanimator]

- selections all drawing
- scale command
* from here on, read what the command bar asks; in parentheses what you have to do)*
- specific base point (the beginning of a quota is ideal)
- scale factor (digita r reference)
- reference length (check the point used for the base point)
- second point (select the final point of the quota)
- specific new length (write the value from the quota)
*now you have real scale design*

Thank you so much, now I try, I hope I'm not too incapable!