quality view

[oriano9080]

Hello everyone!
I can't enable the "quality view" section on the "advanced functions" of the "property" pane of draft views.
I have a ver.18
How can I do that?

 

[gerod]

Hello and welcome.
for the n-th time I remember to read the rules of the forum and to present itself.
It's the first time you write in the forum.

I don't have the 18 (now abandoned) but it seems strange.
maybe downloaded the last service pack of 18 (can be a kiss of the se18).
Hi.

 

[cacciatorino]

Then:

when creating the view, put the flag in the box as in the image attached, after which you will have the function you ask. is only valid for mass in the board of assemly.

 

[oriano9080]

I have already done this, but then I can't use the shading anymore
and this is very conditioning, and then let's say that I can't use it for pars.
Now it is true that I have an old ver, and I cannot, because in the vers. has my problem been overcome?

 

[cacciatorino]

I have already done this, but then I can't use the shading anymore
and this is very conditioning, and then let's say that I can't use it for pars.
Now it is true that I have an old ver, and I cannot, because in the vers. has my problem been overcome?

but what do you need this function? I've never used it so far. Do you have to put big bikes on the table?

 

[oriano9080]

Yes, they're big enough, and I'll do this for you.
exploding instructions booklets, and also producing jpg images that can always be used for the same purpose.Unfortunately I do not see the way but it makes me anger because other designers with other programs make it obtaining perfect prints even if you enlarge considerably.

 

[gerod]

the way there is and works (I use it with the 20).
I repeat, I remember well but the 18 had problems on the dfts that were solved with some sp.
You better upgrade to the last sp before you say "it doesn't work."
Do the update and then see what he says.
Hi.

 

[cacciatorino]

Yes, they're big enough, and I'll do this for you.
exploding instructions booklets, and also producing jpg images that can always be used for the same purpose.Unfortunately I do not see the way but it makes me anger because other designers with other programs make it obtaining perfect prints even if you enlarge considerably.

have you tried to force the display to 300 dpi, even in print phase?

for gerod: I have if v18 updated to the last sp and behaves as described by the user.

 

[oriano9080]

before writing to the forum I had already set up the 300 dpi but unfortunately
He hasn't changed me much.
You'd know how to tell me that there's a problem about the sp.
have I installed the sp3 for a long time?
Hi.

 

[cacciatorino]

before writing to the forum I had already set up the 300 dpi but unfortunately
He hasn't changed me much.
You'd know how to tell me that there's a problem about the sp.
have I installed the sp3 for a long time?
Hi.

I have the sp12 but it does so and which to yours, maybe you should switch to a later version of solid edge but I think I understand that, like me, you are stuck to v18.

 

[oriano9080]

you used the right term "locked to the ver.18" but I will see to pass over.
Thank you so much for the moment.... hello

 

[gerod]

I didn't know there was this limit on 18.
go to the top then.
Hi.