question ansys cfx

[Leonardo.G]

Bye to all,
from about a month I was working on a simulation in ansys 13 fluid flow cfx concerning the study of corners of a 45 m tall building.
I wanted to ask anyone who can give me a hand, if you can set the effect of the incoming wind not in a linear way, but so that the limit layer that is generated for the effect of the friction of the ground is respected.
In fact, the project was estimated on the ground floor a wind speed of 20 m/s and on the upper floors of about 41 m/s .

 

[stefano.garbin]

leonardo, unfortunately here in this forum we treat thermo-structural and non-fluodynamic problems.

 

[Leonardo.G]

I'm so sorry, it wasn't my intention.

 

[gerod]

... but if anyone comes through here and gives you a better help.
there is no dedicated section for cfx so I would leave it anyway in "ansys".
Greetings.