fcara
Guest
Hello everyone, I am moving the first steps with the demo version of the program and I would have some very "generic" questions. I have always analyzed simple frames trying to familiarize with the program, but now for exercise I would like to go to analyze a cylindrical container in sheet with a certain pressure inside.
My main doubts are:
1) once the design is exported and made the surface mesh, as I do for example to represent variations of thickness only in certain areas, due for example to the presence of reinforcements: Is it enough to represent them in the design I go to export?
2) If there are flanged mouths on this cylinder, should I represent these flanges with brick or always surface elements?
every advice is well accepted, thanks to all:smile:
My main doubts are:
1) once the design is exported and made the surface mesh, as I do for example to represent variations of thickness only in certain areas, due for example to the presence of reinforcements: Is it enough to represent them in the design I go to export?
2) If there are flanged mouths on this cylinder, should I represent these flanges with brick or always surface elements?
every advice is well accepted, thanks to all:smile:
