quotation rack

[otta88]

Hello everyone! I'm new here, I just read the rules and hope I don't miss anything. .
I wanted to ask for your help regarding the quotation of a rack, I'm not sure you do it this way.
I searched the forum but found nothing about it.
It is a type of rack that is located inside a pneumatic actuator and that I, in all honesty, modeled manually through catia v5.
I need a college exam.
I attach an image of the piece I quote.
Thank you in advance :finger:

 

[meccanicamg]

Bye. I would say there are two things that I'm not doing well:

1) to make medium order with quotas, especially those of the interrupted diameters that would be to make them all on the same side or above or below.

2) that rack quoted so that it is not right. is quoted according to legislation, in a table or with a note the form of the teether and the step. if for some reason you don't want to synthesize you have to quote angle, step between two ridges, primitive, addendum and dedendum. In short, what about the rack is like for the gears.
search for the formulas of the racks and you will see how they size and how they represent. It would be good that I had books and manuals suitable to deal with the drawing course.