sifulee
Guest
Hello everyone,
I am working in 3d inch units having set the config.pro in decimal format: I would like to know if it is possible to set in the table, by default, the fractional format of the quotation in in inches, but keeping the odds of the 3d sketches in decimal format; moreover it is possible to insert in the suffix, by default, the " symbol of the thumbs, so I do not need to write it every time on the single quota?
Thank you very much!
I am working in 3d inch units having set the config.pro in decimal format: I would like to know if it is possible to set in the table, by default, the fractional format of the quotation in in inches, but keeping the odds of the 3d sketches in decimal format; moreover it is possible to insert in the suffix, by default, the " symbol of the thumbs, so I do not need to write it every time on the single quota?
Thank you very much!