Piero_Bo
Guest
hi to everyone, it should be my first message since I was registered, I searched online but I did not find answer to my problem.
they asked me to give thickness to two drawings, a rack and a gear, and up to this zero problems.
from what they told me are both modules 1.
I did the axieme and used the movement bond but did not move properly, my question is: how can I calculate the value that asks me inventor to make that gear and rack move simultaneously? and how do I calculate the exact inter axis position between the gear center in relation to the rack?
thanks to whom I can help
piero
they asked me to give thickness to two drawings, a rack and a gear, and up to this zero problems.
from what they told me are both modules 1.
I did the axieme and used the movement bond but did not move properly, my question is: how can I calculate the value that asks me inventor to make that gear and rack move simultaneously? and how do I calculate the exact inter axis position between the gear center in relation to the rack?
thanks to whom I can help
piero