ragnation on bronzine

[ironlomo]

Good evening, everyone!

My problem is as follows:
I have to draw a bronzine with a ragnatura inside.

Only once I draw the inner circumference I can't tilt it, I practically get a straight channel. .

How can I overcome the problem? I tried to tilt it but zero results.
I hope I've explained enough. . . !

 

[MassiVonWeizen]

bidemensional or three-dimensional?

In the second case I wouldn't know how to help you, because I don't use mechanical for the 3d, but I think there is a sweep or similar function.

in the first it seems quite trivial, but perhaps I do not understand what you want to get; Set the ragnature step and its width, then connect the gorge centers diametrically opposite (and distant the step) and make a mid-throat offset. cuts, stretches, some tangency, bevels and rays enough and serve at the table

 

[ironlomo]

Okay perfect! ! !

I'll try immediately!
I think in 2d it's all right! ! !
Thank you!