realization of the situation

[foxstone]

Good morning, everyone.
I'm new to the forum. I would like to ask, to whom do you understand, a question about the modeling of murals in revit.
I'll give you a little preamble to make you understand what I'm looking for.
I have to design a renovation with a veneto case (1920-1930, full masonry of 15 cm) and as usual there is no wall that is perpendicular and parallel to another.
I imported the .dwg file, with all its imperfections but revit is not going to make me a wall that matches the imported file.
the question: how can I model the walls that match the imported file?? revit with snaps doesn't accept it or it makes me mistake.

 

[Tristan]

go of local modeling in place

 

[paolo40]

Maybe it would be enough to place near the nodes and press the tab button repeatedly. other speech if the walls are thick variable in the plant, but here mom autodesk seems not to want to hear us. Yet it would be so little, even because a variable geometry core with parallel finishing layers would be sufficient....(my modest opinion)

 

[foxstone]

Thank you very much paolo40,
I solved my problem!! !