realization roof with hanging

[ossosso]

Hello everyone,
I would need to make a roof with this confoermazione seen in section:
http://www.ossosso.com/scambio/shooot.jpgin practice the roof comes to wall wire and then there is a component of smaller thickness that protrudes.
that is why it is so that he will have to see himself in section.

Is there a way?

Thank you very much in advance.

bye!

 

[Alfredo Medina]

maybe with "tect: band" and a profile with that rectangle?

 

[Tristan]

should the stratification be seen? when I had need I made 2 different roofs, one (sportsman) superimposed to the other (fine dock)

 

[ossosso]

Thanks, guys.
I tried with the "fascia" with that section, but it actually works along the horizontal perimeter of the roof, but along the ground the angle just pops up.

a solution was that of the double roof, but in the end I preferred to create an additional roof not overlapped but perimeter, as was the same offset roof of 30 outwards with a large inner hole; It seems to me the most elegant method, also regarding the section.

Thank you so much!

 

[nativo]

I tried with the "fascia" with that section, but it actually works along the horizontal perimeter of the roof, but along the ground the angle just pops up.

Are you crazy? I don't think so, if you parameterize it correctly.

However the solution of tristan seems to me the most correct because more responsive to reality.... (here in Trentino)

 

[nativo]

I forgot to write that if you only care about the graphic result at the level of detail, you can use the "cut profile" icon on the ribbon -view - graphics.

 

[Alfredo Medina]

with the roof option: band would be like this:
dope you can hide the lines that are not necessary.