recognition of imported functions

[gtsolid]

Hello, everyone.
In this beautiful base I should remove parts as they create points of contact singularity:The point is, it's all "imported." Is there an automatic recognition of functions?
if not use cut-outs in manual

 

[MassiVonWeizen]

you can do aitomatic recognition, but on a monobloc piece (who is the hallucinate that shaped him?) it is suicide.
You're less cut off

 

[gtsolid]

It comes from solidedge. That's the thing.
if --> step --> sw.
sw opens it like a monoblock

 

[MassiVonWeizen]

in itself was made monobloc? If not, can you train the step?
if in sw it is monobloc the recognition functions you recreate it such and you do it just more than before.

 

[gtsolid]

Yeah, a piece was made of monoblock, say 90%, then the rest is done by functions. This on if.
I've seen that there are joint functions on sw investigating fine geometries, etc... Maybe they do my case, now I try

 

[MassiVonWeizen]

I've seen that there are joint functions on sw investigating fine geometries

I don't know what you're talking about. Anyway, you're working in part.